Preparation of poly(ether sulfone) nanofibers by gas‐jet/electrospinning

Citations Over TimeTop 20% of 2007 papers

Abstract

Abstract Poly(ether sulfone) (PES) nanofibers were prepared by the gas‐jet/electrospinning of its solutions in N,N ‐dimethylformamide (DMF). The gas used in this gas‐jet/electrospinning process was nitrogen. The morphology of the PES nanofibers was investigated with scanning electron microscopy. The process parameters studied in this work included the concentration of the polymer solution, the applied voltage, the tip–collector distance (TCD), the inner diameter of the needle, and the gas flow rate. It was found from experimental results that the average diameter of the electrospun PES fibers depended strongly on these process parameters. A decrease in the polymer concentration in the spinning solutions resulted in the formation of nanofibers with a smaller diameter. The use of an 18 wt % polymer solution yielded PES nanofibers with an average diameter of about 80 nm. However, a morphology of mixed bead fibers was formed when the concentration of PES in DMF was below 20 wt % during gas‐jet/electrospinning. Uniform PES nanofibers with an average diameter of about 200 nm were prepared by this electrospinning with the following optimal process parameters: the concentration of PES in DMF was 25 wt %, the applied voltage was 28.8 kV, the gas flow was 10.0 L/min, the inner diameter of the needle was 0.24 mm, the TCD was 20 cm, and the flow rate was 6.0 mL/h. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 2008

Related Papers

• → Structural Control of Nanofibers According to Electrospinning Process Conditions and Their Applications(2023)33 cited
• → Nanofibers: principles and manufacture(2012)26 cited
• → Controlling the architecture of nanofiber‐coated microfibers using electrospinning(2010)9 cited
• Recent developments in electrospinning of nanofibers and nanofiber yarns(2010)
• Preparation and application of PANI / PEO nanofiber sensor based on electrospinning(2015)