Structure and improved properties of PPC/PBAT blends via controlling phase morphology based on melt viscosity

Citations Over TimeTop 14% of 2020 papers

Abstract

ABSTRACT Poly(propylene carbonate) (PPC)/poly(butylenes adipate‐co‐terephthalate) (PBAT) blends with various composition ratios were prepared via melt mixing using a twin‐screw extruder. The effect of melt viscosities of polymers on mechanical behavior, interfacial interaction, thermal properties, rheological responses, and phase morphology was investigated. Results showed that the phase morphology and properties of PPC/PBAT blends were affected by the composition of the blends and the melt viscosities of the two polymers. Results of tensile tests, FTIR, and dynamic rheological measurement of PBAT‐rich blends exhibited a better mechanical properties, intermolecular interactions, and compatibility when compared with PPC‐rich blends due to the differences of their melt viscosities. Incorporating of PBAT effectively improved the T g of PPC and the thermal stability of the blends. The T c of PPC/PBAT blends markedly increased from 37.5 to 66.8 °C with addition of only 10 wt% PPC, indicating an enhanced crystallization ability of PBAT. The improvement of T c was helpful for blown film extrusion. SEM microphotographs showed that the size of the dispersed phase particles is much smaller and the distribution is more uniform for PBAT‐rich blends, compared with that in PPC‐rich blends. The processing stability of blown film extrusion was improved by blending PPC with PBAT. © 2020 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2020 , 137 , 48924.

Related Papers

• → Extrusion-Based Microencapsulation for the Food Industry(2014)6 cited
• Improvement of extrusion system for 6000kN extruder(2012)
• Direct Extrusion Technology with a Co-rotating Twin-screw Extruder(2001)
• → A Treatise on the Screw Extrusion of Thermoplastics : Part IV, Experimental Studies about the Extrusion of Polyvinyl Chloride(1961)
• → Extrusion(1995)