Field testing of thermoplastic encapsulants in high‐temperature installations

Citations Over TimeTop 23% of 2015 papers

Abstract

Abstract Recently there has been increased interest in using thermoplastic encapsulant materials in photovoltaic modules, but concerns have been raised about whether these would be mechanically stable at high temperatures in the field. Recently, this has become a significant topic of discussion in the development of IEC 61730 and IEC 61215. We constructed eight pairs of crystalline‐silicon modules and eight pairs of glass/encapsulation/glass thin‐film mock modules using different encapsulant materials, of which only two were formulated to chemically crosslink. One module set was exposed outdoors with thermal insulation on the back side in Mesa, Arizona, in the summer (hot‐dry), and an identical module set was exposed in environmental chambers. High‐precision creep measurements (±20 μ m) and electrical performance measurements indicate that despite many of these polymeric materials operating in the melt or rubbery state during outdoor deployment, no significant creep was seen because of their high viscosity, lower operating temperature at the edges, and/or the formation of chemical crosslinks in many of the encapsulants with age despite the absence of a crosslinking agent. Only an ethylene‐vinyl acetate ( EVA ) encapsulant formulated without a peroxide crosslinking agent crept significantly. In the case of the crystalline‐silicon modules, the physical restraint of the backsheet reduced creep further and was not detectable even for the EVA without peroxide. Because of the propensity of some polymeric materials to crosslink as they age, typical thermoplastic encapsulants would be unlikely to result in creep in the vast majority of installations.

Related Papers

• → Dependence of Basic Creep on the Relative Humidity(2023)3 cited
• → Long-term creep strength predictions from short-term creep test data for high Cr creep-resistant steels and microstructural evolution origin of over-predictions(2018)9 cited
• Determination of elastic and creep properties of thin-film systems from indentation experiments(2000)
• → Creep Life Prediction Method by Using High-Temperature Indentation Creep Test(2018)3 cited
• INVESTIGATION THE CREEP AND CREEP RECOVERY BEHAVIOR OF BUILD-UP SYSTEMS(2017)