Rapid Microfluidic Mixing

Citations Over TimeTop 1% of 2001 papers

Abstract

A preformed T-microchannel imprinted in polycarbonate was postmodified with a pulsed UV excimer laser (KrF, 248 nm) to create a series of slanted wells at the junction. The presence of the wells leads to a high degree of lateral transport within the channel and rapid mixing of two confluent streams undergoing electroosmotic flow. Several mixer designs were fabricated and investigated. All designs were relatively successful at low flow rates (0.06 cm/s, > or = 75% mixing), but had varying degrees of success at high flow rates (0.81 cm/s, 45-80% mixing). For example, one design operating at high flow rates was able to split an incoming fluorescent stream into two streams of varying concentrations depending on the number of slanted wells present. The final mixer design was able to overcome stream splitting at high flow rates, and it was shown that the two incoming streams were 80% mixed within 443 microm of the T-junction for a flow rate of 0.81 cm/s. Without the presence of the mixer and at the same high flow rate, a channel length of 2.3 cm would be required to achieve the same extent of mixing when relying upon molecular diffusion entirely, while 6.9 cm would be required for 99% mixing.

Related Papers

• → An efficient micromixer actuated by induced-charge electroosmosis using asymmetrical floating electrodes(2018)43 cited
• → Focusing-enhanced mixing in microfluidic channels(2008)42 cited
• → Rapid Microfluidic Mixing Method Based on Droplet Rotation Due to PDMS Deformation(2021)9 cited
• → <title>Active microfluidic mixer for mixing of microparticles and liquids</title>(2000)5 cited
• → Nature-Inspired Active Mixing in a Microchannel(2006)