Higher Sensitivity Dopamine Measurements with Faster-Scan Cyclic Voltammetry

Citations Over TimeTop 1% of 2011 papers

Abstract

Fast-scan cyclic voltammetry (FSCV) with carbon-fiber microelectrodes has been successfully used to detect catecholamine release in vivo. Generally, waveforms with anodic voltage limits of 1.0 or 1.3 V (vs Ag/AgCl) are used for detection. The 1.0 V excursion provides good temporal resolution but suffers from a lack of sensitivity. The 1.3 V excursion increases sensitivity but also increases response time, which can blur the detection of neurochemical events. Here, the scan rate was increased to improve the sensitivity of the 1.0 V excursion while maintaining the rapid temporal response. However, increasing scan rate increases both the desired faradaic current response and the already large charging current associated with the voltage sweep. Analog background subtraction was used to prevent the analog-to-digital converter from saturating from the high currents generated with increasing scan rate by neutralizing some of the charging current. In vitro results with the 1.0 V waveform showed approximately a 4-fold increase in signal-to-noise ratio with maintenance of the desired faster response time by increasing scan rate up to 2400 V/s. In vivo, stable stimulated release was detected with an approximate 4-fold increase in peak current. The scan rate of the 1.3 V waveform was also increased, but the signal was unstable with time in vitro and in vivo. Adapting the 1.3 V triangular wave into a sawhorse design prevented signal decay and increased the faradaic response. The use of the 1.3 V sawhorse waveform decreased the detection limit of dopamine with FSCV to 0.96 ± 0.08 nM in vitro and showed improved performance in vivo without affecting the neuronal environment. Electron microscopy showed dopamine sensitivity is in a quasi-steady state with carbon-fiber microelectrodes scanned to potentials above 1.0 V.

Related Papers

• → Potentiodynamically deposited nanostructured manganese dioxide as electrode material for electrochemical redox supercapacitors(2004)189 cited
• → Catalytic Application of Gold Nanoparticles Electrodeposited by Fast Scan Cyclic Voltammetry to Glycerol Electrooxidation in Alkaline Electrolyte(2011)38 cited
• → Effect of Electrochemical Factors on Formation and Reduction of Silver Oxides(2013)26 cited
• → Tuning electrochemical and morphological properties of Prussian blue/carbon nanotubes films through scan rate in cyclic voltammetry(2019)16 cited
• → Electrodeposition of Nano-Structured PbO2 on Glassy Carbon Electrodes by FFT Continuous Cyclic Voltammetry(2012)12 cited