Fabrication of Nanocolumns for Liquid Chromatography

Citations Over TimeTop 1% of 1998 papers

Abstract

This paper shows that in situ micromachining can be used to simultaneously position and define (i) support particles, (ii) convective transport channels, (iii) an inlet distribution network of channels, and (iv) outlet channels in multiple chromatography columns on a single quartz wafer to the level of a few tenths of a micrometer. Stationary phases were bonded to 5 x 5 x 10 microns collocated monolith support structures separated by rectangular channels 1.5 microns wide and 10 microns deep with a low degree of deviation of channel width between the top and bottom of channels. High aspect ratio microfabrication can only be achieved with deep reactive ion etching. The volume of a 150 microns x 4.5 cm column was 18 nL. Column efficiency was evaluated in the capillary electrochromatography (CEC) mode using rhodamine 123 and a hydrocarbon stationary phase. Plate heights in these columns were typically 0.6 micron in the nonretained and 1.3 microns in the retained modes of operation. Columns were designed to have identical mobile-phase velocity in all channels in an effort to minimize outgassing during operation. When the total lateral cross-sectional area of channels at all points along the separation axis is identical, linear velocity of the mobile phase in a CEC column should be the same. Columns were operated at atmospheric pressure.

Related Papers

• A GEOMETRIC MEAN IN THE FURUTA INEQUALITY(2002)
• Susquehanna Chorale Spring Concert "Roots and Wings"(2017)
• Коммуникaтивно- прaгмaтический aнaлиз дипломaтических бумaг (нa основе вербaльных нот)(2018)
• → ФОРМИРОВAНИЕ ГОТОВНОСТИ БУДУЩИХ ПЕДAГОГОВ К ОРГAНИЗAЦИИ РAБОТЫ ПО РAЗВИТИЮ ВAЛЕОЛОГИЧЕСКОЙ КУЛЬТУРЫ ШКОЛЬНИКОВ(2023)