Characterization of Polyether and Polyester Polyurethane Soft Blocks Using MALDI Mass Spectrometry

Citations Over TimeTop 10% of 2000 papers

Abstract

Selective degradation reactions combined with MALDI analysis have been applied for molecular weight (MW) determination of polyether and polyester polyurethane (PUR) soft blocks. Selective degradation allows recovery of the polyols, and direct observation of the soft block oligomer distribution is possible for the first time by using MALDI. Ethanolamine is applied for polyether PUR degradation. MALDI analysis indicates that the recovered polytetrahydrofuran (pTHF) MW distribution is nearly identical to the unreacted pTHF material. Reduction in the ethanolamine reaction time allows observation of oligomer ions containing the diisocyanate linkage, which provide identification of the diisocyanate. Ethanolamine is not used for polyester PUR's degradation because the ester bonds will be cleaved. Therefore, phenylisocyanate is applied for polyester PUR degradation. Polybutylene adipate (pBA) oligomers were directly observed in the MALDI spectra of the degraded pBA-PUR samples. Comparison of the degraded pBA-PUR oligomer distribution with the unreacted pBA material indicates that low-mass oligomers are less abundant in the degraded pBA-PURs. Oligomer ions containing the diisocyanate linkage are also observed in the spectrum, providing a means for identifying the diisocyanate used for PUR syntheses. Size-exclusion chromatography (SEC) was combined with MALDI to provide accurate MW determination. Narrow MW fractions of the degraded and unreacted polyols were collected and analyzed by MALDI. This method allows precise calibration of the SEC chromatogram. The SEC-MALDI results provide significantly larger Mw and PD values than MALDI alone. Using SEC-MALDI, it was determined that the PD indexes of the pTHF and pBA samples are larger than the assumed values, which are based on the polyol synthesis reactions. The combination of selective degradation with SEC-MALDI, using either ethanolamine or phenylisocyanate, is a viable method for polyurethane polyol characterization.

Related Papers

• → Kinetic Features of Isophorone Diisocyanate and Oligoesterdiols Reaction under Waterborne Polyurethane Synthesis Conditions and the Preparation of the Polymer Dispersions(2020)3 cited
• → Application of an oligomer as an internal standard in gel permeation chromatography(1974)21 cited
• Study on Synthesis and Properties of Water-borne Polyurethane Based on Castor oil Polyol(2012)
• Synthesis of Alkali-soluble Photosensitive Oligomer Containing Si(2010)
• Synthesis of an alkali-soluble photosensitive polysiloxane oligomer(2010)