Evaluation of Electrode and Solution Area-Based Resistances Enables Quantitative Comparisons of Factors Impacting Microbial Fuel Cell Performance
Citations Over TimeTop 10% of 2019 papers
Abstract
Direct comparisons of microbial fuel cells based on maximum power densities are hindered by different reactor and electrode sizes, solution conductivities, and materials. We propose an alternative method here, the electrode potential slope (EPS) analysis, to enable quantitative comparisons based on anode and cathode area-based resistances and operating potentials. Using EPS analysis, the brush anode resistance ( RAn = 10.6 ± 0.5 mΩ m2) was shown to be 28% lower than the resistance of a 70% porosity diffusion layer (70% DL) cathode ( RCat = 14.8 ± 0.9 mΩ m2) and 24% lower than the solution resistance ( RΩ = 14 mΩ m2) (acetate in a 50 mM phosphate buffer solution). Using a less porous cathode (30% DL) did not impact the cathode resistance but did reduce the cathode performance due to a lower operating potential. With low-conductivity domestic wastewater ( RΩ = 87 mΩ m2), both electrodes had higher resistances [ RAn = 75 ± 9 mΩ m2, and RCat = 54 ± 7 mΩ m2 (70% DL)]. Our analysis of the literature using EPS analysis shows how electrode resistances can easily be quantified to compare system performance when the electrode distances are changed or the sizes of the electrodes are different.
Related Papers
- → Effect of increasing anode surface area on the performance of a single chamber microbial fuel cell(2009)188 cited
- → Enhanced simultaneous decolorization of azo dye and electricity generation in microbial fuel cell (MFC) with redox mediator modified anode(2016)91 cited
- → Novel microbial fuel cell design to operate with different wastewaters simultaneously(2015)45 cited
- → A multi-anode paper-based microbial fuel cell for disposable biosensors(2013)5 cited
- Novel microbial fuel cell design to operate with different wastewaters simultaneously(2016)