Low Dielectric Polyimide Aerogels As Substrates for Lightweight Patch Antennas
Citations Over TimeTop 10% of 2012 papers
Abstract
The dielectric properties and loss tangents of low-density polyimide aerogels have been characterized at various frequencies. Relative dielectric constants as low as 1.16 were measured for polyimide aerogels made from 2,2'-dimethylbenzidine (DMBZ) and biphenyl 3,3',4,4'-tetracarbozylic dianhydride (BPDA) cross-linked with 1,3,5-triaminophenoxybenzene (TAB). This formulation was used as the substrate to fabricate and test prototype microstrip patch antennas and benchmark against state of practice commercial antenna substrates. The polyimide aerogel antennas exhibited broader bandwidth, higher gain, and lower mass than the antennas made using commercial substrates. These are very encouraging results, which support the potential advantages of the polyimide aerogel-based antennas for aerospace applications.
Related Papers
- → Current status, opportunities, and challenges in fuel cell catalytic application of aerogels(2019)44 cited
- → Synthesis of aerogel foams through a pressurized sol-gel method(2020)18 cited
- → Utilization of aerogel in building construction –A Review(2020)19 cited
- → Electrical conduction of polyimide films prepared from polyamic acid (PAA) and pre-imidized polyimide (PI) solution(2008)8 cited
- Aerogel + Aerogel = Aerogel²Developments on Aerogel-Aerogel Composites(2011)