Antimony-Doped Tin(II) Sulfide Thin Films
Citations Over TimeTop 10% of 2012 papers
Abstract
Thin-film solar cells made from earth-abundant, inexpensive, and nontoxic materials are needed to replace the current technologies whose widespread use is limited by their use of scarce, costly, and toxic elements.(1) Tin monosulfide (SnS) is a promising candidate for making absorber layers in scalable, inexpensive, and nontoxic solar cells. SnS has always been observed to be a p-type semiconductor. Doping SnS to form an n-type semiconductor would permit the construction of solar cells with p-n homojunctions. This paper reports doping SnS films with antimony, a potential n-type dopant. Small amounts of antimony (∼1%) were found to greatly increase the electrical resistance of the SnS. The resulting intrinsic SnS(Sb) films could be used for the insulating layer in a p-i-n design for solar cells. Higher concentrations (∼5%) of antimony did not convert the SnS(Sb) to low-resistivity n-type conductivity, but instead the films retain such a high resistance that the conductivity type could not be determined. Extended X-ray absorption fine structure analysis reveals that the highly doped films contain precipitates of a secondary phase that has chemical bonds characteristic of metallic antimony, rather than the antimony–sulfur bonds found in films with lower concentrations of antimony.
Related Papers
- → Biological Monitoring of Antimony(1988)13 cited
- → Determination of Antimony in Lead-Antimony Alloys of Low Antimony Content(1930)3 cited
- → Antimony and Antimony Alloys(2011)3 cited
- Direct Determination of Lead in Antimony and Antimony Compounds by HG-AFS(2001)