Molecular Oxygen Adsorption Behaviors on the Rutile TiO2(110)-1×1 Surface: An in Situ Study with Low-Temperature Scanning Tunneling Microscopy | doi.page

0 citations0 references

Molecular Oxygen Adsorption Behaviors on the Rutile TiO₂(110)-1×1 Surface: An in Situ Study with Low-Temperature Scanning Tunneling Microscopy

Journal of the American Chemical Society2011Vol. 133(6), pp. 2002–2009

Citations Over TimeTop 10% of 2011 papers

Shijing Tan, Yongfei Ji, Yan Zhao, Aidi Zhao, Bing Wang, Jinlong Yang, Jian Hou

Abstract

A knowledge of adsorption behaviors of oxygen on the model system of the reduced rutile TiO(2)(110)-1×1 surface is of great importance for an atomistic understanding of many chemical processes. We present a scanning tunneling microcopy (STM) study on the adsorption of molecular oxygen either at the bridge-bonded oxygen vacancies (BBO(V)) or at the hydroxyls (OH) on the TiO(2)(110)-1×1 surface. Using an in situ O(2) dosing method, we are able to directly verify the exact adsorption sites and the dynamic behaviors of molecular O(2). Our experiments provide direct evidence that an O(2) molecule can intrinsically adsorb at both the BBO(V) and the OH sites. It has been identified that, at a low coverage of O(2), the singly adsorbed molecular O(2) at BBO(V) can be dissociated through an intermediate state as driven by the STM tip. However, singly adsorbed molecular O(2) at OH can survive from such a tip-induced effect, which implies that the singly adsorbed O(2) at OH is more stable than that at BBO(V). It is interesting to observe that when the BBO(V)s are fully filled with excess O(2) dosing, the adsorbed O(2) molecules at BBO(V) tend to be nondissociative even under a higher bias voltage of 2.2 V. Such a nondissociative behavior is most likely attributed to the presence of two or more O(2) molecules simultaneously adsorbed at a BBO(V) with a more stable configuration than singly adsorbed molecular O(2) at a BBO(V).

Citations Over TimeTop 10% of 2011 papers

Abstract

Related Papers