Control of Neural Stem Cell Adhesion and Density by an Electronic Polymer Surface Switch
Citations Over TimeTop 13% of 2008 papers
Abstract
Adhesion is an essential parameter for stem cells. It regulates the overall cell density along the carrying surface, which further dictates the differentiation scheme of stem cells toward a more matured and specified population as well as tissue. Electronic control of the seeding density of neural stem cells (c17.2) is here reported. Thin electrode films of poly(3,4-ethylenedioxythiophene) (PEDOT):Tosylate were manufactured along the floor of cell growth dishes. As the oxidation state of the conjugated polymer electrodes was controlled, the seeding density could be varied by a factor of 2. Along the oxidized PEDOT:Tosylate-electrodes, a relatively lower density of, and less tightly bonded, human serum albumin (HSA) was observed as compared to reduced electrodes. We found that this favors adhesion of the specific stem cells studied. Surface analysis experiments, such as photoelectron spectroscopy, and water contact angle measurements, were carried out to investigate the mechanisms responsible for the electronic control of the seeding density of the c17.2 neural stem cells. Further, our findings may provide an opening for electronic control of stem cell differentiation.
Related Papers
- → Critical areas of cell adhesion on micropatterned surfaces(2011)106 cited
- → Characterization of Initial Cell Adhesion on Charged Polymer Substrates in Serum-Containing and Serum-Free Media(2018)78 cited
- → Multilayer coatings on biomaterials for control of MG-63 osteoblast adhesion and growth(2008)39 cited
- → Cationized bovine serum albumin with pendant RGD groups forms efficient biocoatings for cell adhesion(2011)15 cited
- Application of ~3H-TdR incorporation assay in the detection of cell-cell adhesion(2002)