Microphase Separation of Segmented Poly(urethane urea) Block Copolymers

Citations Over TimeTop 10% of 2000 papers

Abstract

Two series of well-defined poly(urethane urea) multiblock copolymers were synthesized to investigate the phase-separated morphology of this family of materials. Series I copolymers were synthesized from 2000 g/mol poly(tetramethylene oxide) [PTMO], 4,4‘-methylene di(p-phenyl isocyanate) [MDI], and ethylenediamine (EDA), with hard segment contents ranging from 14 to 47 wt %. Series II copolymers (all with hard segment concentrations of 22 wt %) were prepared from the same PTMO and MDI and a diamine mixture of EDA and 1,4-diaminocyclohexane. The microdomain morphology was characterized using small-angle X-ray scattering, and the scattering data were analyzed using the approach of Bonart and Müller. The series I and II copolymers were found to have relatively low overall degrees of phase separation [ranging from ∼20% at the lowest hard segment contents to greater than 40%], contrary to the common notion that these copolymers are well phase separated materials. The introduction of the second diamine results in reduced phase separation, presumably as a consequence of disruption of hard segment hydrogen bonding.

Related Papers

• → Structural Characterization of Nucleic Acid Nanoparticles Using SAXS and SAXS-Driven MD(2023)6 cited
• → Preparation of cis- and trans-Dichlorobis(ethylenediamine)-Iridium(III) Chlorides(1966)20 cited
• → Complex salts of platinum with ethylenediamine and propanediamine [PtCl(diamine)L][PtCl3L](1990)6 cited
• → Ethylenediamine‐N,N′‐Diacetic Acid Complexes of Cobalt(III)(1978)3 cited
• → IntegrativeSAXS‐Driven Computational Modeling of Biomolecular Complexes(2018)1 cited