Simultaneous Increase in Seebeck Coefficient and Conductivity in a Doped Poly(alkylthiophene) Blend with Defined Density of States

Citations Over TimeTop 10% of 2010 papers

Abstract

The Seebeck coefficient, a defining parameter for thermoelectric materials, depends on the contributions to conductivity of charge carriers at energies away from the Fermi level. Highly conductive materials tend to exhibit conductivity from carriers close to the Fermi level. In this article, we propose polymer blends in which ground state hole carriers, created by doping a minor additive component, are mainly at an orbital energy set below the hole energy of the major component of the blend. Transport, however, is expected to occur through the major component. This leads to a regime in which hole conductivity and Seebeck coefficient may be increased in parallel. While the absolute conductivity of the composite, and thus ZT, are not particularly high, this work demonstrates a route for designing thermoelectric materials in which increases in Seebeck coefficient and conductivity do not cancel each other.

Related Papers

• → Electrical resistivity and Seebeck coefficient of hot-pressed YbAl3 over the temperature range 150-700K(1998)46 cited
• → Synthesis and thermoelectric properties of polyaniline(2003)26 cited
• System to Measure Thermal Conductivity and Seebeck Coefficient for Thermoelectrics(2012)
• Synthesis and Thermoelectric Properties of Polyaniline(2003)
• → Fundamental Knowledge on Thermoelectric Materials(2022)