Soil-specific calibration of capacitance sensors considering clay content and bulk density

Citations Over TimeTop 13% of 2016 papers

Abstract

Soil hydrology research requires the accurate measurement of soil water content. Recently, less expensive capacitance sensors (CS) have become popular for the measurement of soil moisture across soil profiles, but these sensors need to be calibrated for precise results. The purpose of the present study was to determine the effect of clay content and bulk density (?b) on the calibration of CS. Two different CS (10HS and 5TM) were considered for the study. Clay content and ?b of the soils were determined from two different sites and from three different depths (0–5, 25–30 and 50–60 cm) of an experimental field in Gembloux, Belgium. Custom calibration (CC) equations were developed using packed soil columns following the same ?b at sequential volumetric water content (?) levels. The factory-supplied calibration (FSC) showed an overestimation of ? (0.04–0.07 m3 m–3) with the 10HS sensor, and an underestimation of ? (0.06–0.077 m3 m–3) with the 5TM sensor for the entire calibration range. The variance in raw sensor outputs for different ?b and clay content of soil depths was not highly significant because the soil had limited range of variability in ?b and clay content. However, the CC is recommended in parallel with FSC for the precise measurement of soil moisture with CS.

Related Papers

• → Carbon‐sensitive pedotransfer functions for plant available water(2022)68 cited
• → New pedotransfer functions for soil water retention curves that better account for bulk density effects(2020)25 cited
• → Pedotransfer Functions for Estimating Soil Bulk Density Using Image Analysis of Soil Structure(2023)9 cited
• → Use of class pedotransfer functions based on texture and bulk density of clods to generate water retention curves(2003)7 cited
• → Pedotransfer functions for Irish soils – estimation of bulk density (ρ _b ) per horizon type(2015)