Study of mode I crack dynamic propagation behaviour and rock dynamic fracture toughness by using SCT specimens

Citations Over TimeTop 10% of 2018 papers

Abstract

Abstract To study crack dynamic propagation behaviour and rock dynamic fracture toughness, a single cleavage triangle (SCT) specimen was proposed in this paper. By using these specimens and a drop‐weight test system, impact experiments were conducted, and the crack propagation velocity and the fracture time were measured by using crack propagation gauges. To examine the effectiveness of the SCT specimen and to predict the test results, finite difference numerical models were established by using AUTODYN code, and the simulation results showed that the crack propagation path agrees with the test results, and crack arrest phenomena could happen. Meanwhile, by using these numerical models, the crack dynamic propagation mechanism was investigated. Finite element code ABAQUS was applied in the calculation of crack dynamic stress intensity factors (SIFs) based on specimen dimension and the loading curves measured, and the curves of crack dynamic SIFs versus time were obtained. The fracture toughness (including initiation toughness and propagation toughness) was determined according to the fracture time and crack speeds measured by crack propagation gauges. The results show that the SCT specimen is applicable to the study of crack dynamic propagation behaviour and fracture toughness, and in the process of crack propagation, the propagation toughness decreases with crack propagation velocity, and the crack arrest phenomena could happen. The critical SIF of an arrest crack (or arrest toughness) was higher than the crack propagation toughness but was lower than the initiation toughness.

Related Papers

• → Effect of crack closure on non-linear crack tip parameters(2014)45 cited
• → Theoretical study on extension of crack tip plastic zone by remote simple tensile considering crack interaction(2019)11 cited
• → A numerical study of non-linear crack tip parameters(2015)6 cited
• → Three-dimensional Finite Element Analysis of Interfacial Delamination in Molded Underfill Flip-Chip Packages by Virtual Crack Closure Technique(2022)1 cited
• → Crack tip mechanisms: a numerical analysis(2019)1 cited