Imaging discontinuities on seismic sections

Citations Over TimeTop 19% of 1988 papers

Abstract

Abstract In routine seismic processing, normal moveout (NMO) corrections are performed to enhance the reflected signals on common-depth-point or common-midpoint stacked sections. However, when faults are present, reflection interference from the two blocks and the diffractions from their edges hinder fault location determination. Destruction of diffraction patterns by poststack migration further inhibits proper imaging of diffracting centers.This paper presents a new technique which helps in the interpretation of diffracting edges by concentrating the signal amplitudes from discontinuous diffracting points on seismic sections. It involves application to the data of moveout and amplitude corrections appropriate to an assumed diffractor location. The maximum diffraction amplitude occurs at the location of the receiver for which the diffracting discontinuity is beneath the source-receiver midpoint. Since the amplitudes of these diffracted signals drop very rapidly on either side of the midpoint, an appropriate amplitude correction must be applied. Also, because the diffracted signals are present on all traces, one can use all of them to obtain a stacked trace for one possible diffractor location. Repetition of this procedure for diffractors assumed to be located beneath each surface point results in the common-fault-point (CFP) stacked section, which shows diffractor locations by high amplitudes.The method was tested for synthetic data with and without noise. It proves to be quite effective, but is sensitive to the velocity model used for moveout corrections. Therefore, the velocity model obtained from NMO stacking is generally used for enhancing diffractor locations by stacking. Finally, the technique was applied to a field reflection data set from an area south of Princess well in Alberta.

Related Papers

• → Discontinuity spacings in rock(1976)675 cited
• → Discontinuity frequency in rock masses(1983)213 cited
• Constraints for the early detection of discontinuity from motion(1990)
• → Discontinuity location on a Timoshenko beam by using a novel wave reflection technique(2013)3 cited
• → Discontinuity Kinematical Element Method(2020)