Revisiting Multi-Material Composite Structures with Homogenized Composite Properties

Abstract

Composite structures inherently develop residual stresses during their curing process. Driven predominately by mismatched thermal strains between differing materials or ply orientations, but also affected by curing process phenomena like polymer shrinkage, these residual stresses can lead to failure within composite structures. There are several methods varying in complexity that can be used to model the development of residual stresses, all of which are capable of capturing sufficient detail to understand the residual stress state at the ply level. However, explicitly modeling all plies of a layup in a composite structure can be prohibitively expensive based on the number of plies, structure size, and required element size. The computational cost can be reduced through the homogenization of the composite layup without losing much fidelity of the overall response of the structure. The homogenization process reduces the many plies of a laminate to a single lamina that reduces complexity and increases the mesh size where a single element can span multiple plies. This report focuses on verification and validation efforts for a homogenization process using a suite of finite element simulations rather than an analytic solution derived from classical laminate theory. Initial verification using representative element volumes indicated there was minimal error in the homogenization process; however, this compounded to a small, but acceptable error in strip and split ring experimental composite structures. The error does under predict the residual stress state in the strip and split ring and should be accounted for when simulating composite structures with homogenized properties.

Related Papers

• → Influence of shrinkage-reducing agent and polypropylene fiber on shrinkage of ceramsite concrete(2017)77 cited
• Autogenous Shrinkage of Concrete and Its Research Progress(2000)
• The causes and control of shrinkage cracks of concrete(2003)
• Autogenous shrinkage and drying shrinkage of cement paste at early aging(2007)
• Shrinkage Properties of High Performance Concrete with Shrinkage Reducing Agent(2005)