8-antenna and 16-antenna arrays using the quad-antenna linear array as a building block for the 3.5-GHz LTE MIMO operation in the smartphone

Citations Over TimeTop 1% of 2015 papers

Abstract

Using the quad-antenna linear (QAL) array as a building block, the 8-antenna and 16-antenna arrays for the 3.5-GHz long term evolution multiple-input multiple-output (MIMO) operation in the smartphone are demonstrated. The QAL array has a planar structure of narrow width 3 mm (0.035λ) and short length 50 mm (0.58λ), with λ being the wavelength at 3.5 GHz. For the 8-antenna array, two QAL arrays are disposed along two opposite side edges (denoted as Array A) or the same side edge (denoted as Array B) of the system circuit board of the smartphone. The obtained envelope correlation coefficient values of the antennas in Array A and B are shown. The calculated channel capacities for Array A and B applied in an 8 × 8 MIMO system are also analyzed. The 16-antenna array formed by four QAL arrays disposed along two opposite side edges (denoted as Array C) is then studied. For operating in a 16 × 16 MIMO system, the calculated channel capacity of Array C can reach about 66–70 bps/Hz with a 20-dB signal-to-noise ratio. The obtained channel capacity is about 5.7–6.1 times that (11.5 bps/Hz) of the upper limit of an ideal 2 × 2 MIMO system with 100% antenna efficiency for the antennas therein. Details of the proposed Array A, B, and C are described, and the obtained results are presented. © 2016 Wiley Periodicals, Inc. Microwave Opt Technol Lett 58:174–181, 2016

Related Papers

• → Beamforming Comparison of a Multi-Mode Array with a Dipole Array of the Same Aperture Size(2021)2 cited
• → Simulation and Analysis of Arrays Formed by HF Fishbone Antenna(2014)
• → Linear array of 2×2 dual-polarized x-band microstrip patch sub arrays for off-the-grid radar array antenna(2012)
• → Wire array antennas(2001)