Low-temperature direct copper-to-copper bonding enabled by creep on (111) surfaces of nanotwinned Cu

Citations Over TimeTop 10% of 2015 papers

Abstract

Direct Cu-to-Cu bonding was achieved at temperatures of 150-250 °C using a compressive stress of 100 psi (0.69 MPa) held for 10-60 min at 10(-3) torr. The key controlling parameter for direct bonding is rapid surface diffusion on (111) surface of Cu. Instead of using (111) oriented single crystal of Cu, oriented (111) texture of extremely high degree, exceeding 90%, was fabricated using the oriented nano-twin Cu. The bonded interface between two (111) surfaces forms a twist-type grain boundary. If the grain boundary has a low angle, it has a hexagonal network of screw dislocations. Such network image was obtained by plan-view transmission electron microscopy. A simple kinetic model of surface creep is presented; and the calculated and measured time of bonding is in reasonable agreement.

Related Papers

• → Dependence of Basic Creep on the Relative Humidity(2023)3 cited
• → Long-term creep strength predictions from short-term creep test data for high Cr creep-resistant steels and microstructural evolution origin of over-predictions(2018)9 cited
• Determination of elastic and creep properties of thin-film systems from indentation experiments(2000)
• → Creep Life Prediction Method by Using High-Temperature Indentation Creep Test(2018)3 cited
• INVESTIGATION THE CREEP AND CREEP RECOVERY BEHAVIOR OF BUILD-UP SYSTEMS(2017)